ProtoNode Gateway
750-426 29
6. HOW TO START THE INSTALLATION OVER: CLEARING PROFILES
• After setting your PC to be on the same subnet as the ProtoNode (section 4.1), open a web browser on
your PC and enter the IP address of the ProtoNode; the default address is 192.168.1.24.
• If the IP address of the ProtoNode has been changed by previous configuration, you will need to get the
assigned IP address from the network administrator.
• The Web Configurator will be displayed as your landing page.
• At the bottom-left of the page, click the “Clear Profiles and Restart” button.
• Once restart is complete, all the past profiles that were discovered and or added via the Web configurator
will be delete. The unit is now ready to be reinstalled.
To Next Page
Loading...