List of ACU events
D-10 Appendix D: System messages 98-148248-C
0810B-0 ADM ERROR Antenna software
version
An error has occurred during upload of software to
the antenna, the antenna software version is not as
expected. Either the software in the ACU does not
meet the minimum version required by the antenna,
the software image in the ACU is corrupted or the
upload procedure failed because of a communication
error.
0810C-0 ADM ERROR File system integrity One or more file system partitions are corrupt. You
may have lost your settings and collected statistics. If
restarting the system does not help, contact your
service partner.
0810E-0 ADM ERROR RF calibration The RF calibration is not valid.
08800-0 ADM ERROR Internal power supply An internal power supply voltage is outside its allowed
range.
08801-0 ADM ERROR Input voltage too low The input voltage to the power supply is too low. If
running on battery, charge battery for correct
operation.
08802-0 ADM ERROR Input voltage too highThe input voltage to the power supply is too high. If
running on generator or inverter, check for correct
operation.
08840-0 ADM WARNING Master PLL lock The master PLL has lost lock. Check the input
reference signal.
08841-0 ADM ERROR Tuner lock The internal tuner PLL was unable to lock.
08842-0 ADM WARNING GSC demodulator The GSC demodulator has reported an error.
08843-0 ADM WARNING DVBS demodulator The DVBS demodulator cannot be initialised and
loaded correctly.
08844-0 ADM WARNING BUC voltage The BUC voltage is out of range.
08845-0 ADM WARNING LNB voltage The LNB voltage is out of range. The LNB might be
switched off to protect the power supply circuitry.
Reactivate satellite profile to try again, check LNB
cable and surroundings if the problem persists.
08880-0 ADM ERROR WLAN configuration
error
Configuration of WLAN module failed.
08A00-0 ADM WARNING GX Core Module fan There is a problem with the Core Module fan.
Check/clean and replace if necessary.
08A01-0 ADM WARNING GX Core Module
heater
There is a problem with the Core Module heater.
Check and replace if necessary.
Error code Unit Severity Description Explanation
Table D-2: ACU event messages (Continued)
To Next Page
Loading...
Need help?
General