InteliLite 9 Global Guide
235
Setpoint group CM-Ethernet Related FW 1.1.0
Range [units] 0..31 characters [-]
Default value [-] Alternative config NO
Step [-]
Comm object 24367 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
Enter an existing email address into this setpoint. This address will be used as sender address in active e-
mails that will be sent from the controller.
Note: It is not needed to enter an existing email address, nevertheless valid email format needs to be
followed.
IMPORTANT: This item is obligatory when emails are configured.
SMTP Sender Address
6 back to List of setpoints
Setpoint group CM-Ethernet Related FW 1.1.0
Range [units] FIXED / AUTOMATIC [-]
Default value AUTOMATIC Alternative config NO
Step [-]
Comm object 24259 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
The setpoint is used to select the method how the ethernet connection is adjusted.
DISABLED: The Ethernet connection is fixed by means of the setpoints IP Addr, NetMask, GateIP,
DNS IP Address.
This method should be used for a classic Ethernet or internet connection. When this type
of connection opens, the controller is specified by its IP address. This means that it
would be inconvenient if the IP address were not fixed (static).
ENABLED: The Ethernet connection setting is obtained automatically from the DHCP server. The
obtained settings are then copied to the related setpoints. If the process of obtaining the
settings from the DHCP server is not successful, the value 000.000.000.000 is copied to
the setpoint IP address and the module continues to try to obtain the settings.
IP Address Mode
6 back to List of setpoints
To Next Page
Loading...
Need help?
General
