Response Message Button
You may program a RESPONSE MESSAGE button, which allows you to send an
LCD message to a caller who has initiated a SOHVAor intercom call from another
LCD speakerphone, or to send an LCD message to another LCD speakerphone that
you call and receive a busy signal or no answer.
•
To store a scrolling RESPONSE MESSAGE button, proceed
as follows (user may press button repeatedly to choose from
up to 30 system supplied messages),
1. PRESS INTERCOM.
2. DIAL
**6.
3. PRESS programmable button for RESPONSE MESSAGE button
location.
4. DIAL
00.
5. DIAL
# to save programming.
6. PRESS SPEAKER to end.
7. LABEL button location.
•
To store a fixed RESPONSE MESSAGE button (delivers the
same message each time it is pressed),
1. PRESS INTERCOM.
2. DIAL
**6.
3. PRESS programmable button for RESPONSE MESSAGE button
location.
4. DIAL message number (01-30) from list of messages.
NOTE: Programmed messages available for use are created by the system
attendant and listed in a table on page 47.
5. DIAL
# to save programming.
6. PRESS SPEAKER to end.
7. LABEL button location.
LCD Speakerphone Station User’s Guide 59
GCA70-258 Programming
To Next Page
Loading...
