58 Artiglio Master Code User Manual
MOUNTING
Always check that the tyre/rim combination is correct in terms of compatibility
(tubeless tyre on tubeless rim; tube type tyre on tube type rim) and geometrical size
(keying diameter, cross-section width, off-set and shoulder profile) before mounting.
Also check that rims are not deformed, that their fixing holes have not become
oval, that they are not scaled or rusty and that they do not have sharp burrs on the
valve holes.
Check that the tyre is in good condition with no signs of damage.
WARNING
1- Thoroughly lubricate the sidewalls of the tyre
around the entire circumference of the lower and
upper bead (Fig. 37a).
2- Operate the control to remove the disc
from the work area.
3- The tool is already positioned at the correct
height for assembling the first bead, (Fig. 36b), and
manually work the tyre so that the upper shoulder
of the rim bypasses the lower bead and goes into
the rim well (Figs. 37b - 37c).
4- Press (see Fig. 37d), to enable the se-
quence for assembling the first bead.
37a
37c
37b
37d
To Next Page
Loading...
