19 2813
Program ‘‘CLOCK’’ (TIME OF DAY) into Unit as instructed in the SERVICE AND MAINTENANCE section.
PROGRAMMING ‘‘DEFROST’’ (AUTOMATIC) SETTINGS INTO the UNIT
The automatic defrost system may be programmed into the Unit to occur up to nine different times during a day
with a minimum of two hours between defrost time settings. Program automatic defrost time settings into the
Unit as instructed in the SERVICE AND MAINTENANCE section.
PROGRAMMING ‘‘SLEEP’’ (SLEEP TIME) INTO the UNIT
‘‘SLEEP’’ (SLEEP TIME) may be programmed into the Unit to occur any time of the day after the Unit automatic
defrost cycle has occurred. The Unit will shut down (go into sleep time) and will not wake up (return to normal
operation) until programmed ‘‘WAKE UP’’ (WAKE UP TIME) has occurred. Program ‘‘SLEEP’’ (SLEEP TIME)
into the Unit as instructed in the SERVICE AND MAINTENANCE section.
PROGRAMMING ‘‘WAKE UP’’ (WAKE UP) TIME INTO the UNIT
‘‘WAKE UP’’ (WAKE UP TIME) May be programmed into the Unit to occur any time of the day to wake the Unit
up (return to normal operation) after ‘‘sleep time’’ has occurred. Program ‘‘WAKE UP’’ into the Unit as instructed
in the SERVICE AND MAINTENANCE section.
PROGRAMMING POINT OF SALE MESSAGE DISPLAY
Three point of sale display messages are available to choose from and may be programmed into the Unit by
placing No. 1 and No. 2 switches on DIP SWITCH assembly on master circuit board in appropriate positions.
Program point of sale display messages into the Unit as instructed in the SERVICE AND MAINTENANCE
section.
ADJUSTING ‘‘VIS SET’’ (PRODUCT VISCOSITY) OF DISPENSED PRODUCT
Adjust ‘‘VIS SET’’ (PRODUCT VISCOSITY) determines what product consistency of the dispensed product will
be present in each freeze cylinder. Adjust ‘‘VIS SET’’ (PRODUCT VISCOSITY) of the dispensed product as
instructed in the SERVICE AND MAINTENANCE section.
“VIS READ” (ACTUAL VISCOSITY READOUT) OF PRODUCT IN FREEZE CYLINDERS
“VIS READ” (actual viscosity readout) may be brought up on the message display to actually read the viscosity
(product consistency) of product in the freeze cylinders while the Unit is in operation as instructed in SERVICE
AND MAINTENANCE section.
DISPLAYED EVAPORATOR REFRIGERATION COILS INLETS AND COMMON OUTLET
SENSORS TEMPERATURES
Evaporator refrigeration coils inlet and common outlet temperature readings in degrees Fahrenheit may be
displayed on the message display as instructed in the SERVICE AND MAINTENANCE section.
‘‘VOLTAGE’’ (DISPLAYED VOLTAGE READOUT)
Displayed voltage readout may be displayed on the message display as instructed in the SERVICE AND
MAINTENANCE section.
To Next Page
Loading...
