Page 12
ACCESSING PROGRAM MODE FOR THE FIRST TIME
GENERAL INFORMATION
There are two program modes in the PW64 panel. The first is the “Client” Program Mode to allow a system User to
Add, Change or Delete User Codes.
The second mode is the “Installer” Program Mode. The Installer Program Mode allows ALL programmed data to
be changed. Access to both Modes is described below.
ACCESS TO INSTALLER PROGRAMMING ON POWER UP
When power is applied to the controller for the first time, with the panel tamper input open and none of the
Areas either Armed or in Stay mode, the panel will inhibit tamper alarms and ready the panel to enter
INSTALLATION PROGRAM Mode (unless the Installer Lock-out option P601E4E has previously been enabled). At
this point you can go to the keypad which is connected to the panel and;
Press –”PROGRAM”-”ENTER”
which will automatically put the keypad into Installation Program mode, The LCD display will show “INSTALLER
MODE”.
ACCESS TO PROGRAM MODES FROM RUN MODE
Before you can enter program mode from the normal Run Mode, the panel must be disarmed and not in stay mode.
Then;
Press <PROGRAM> - <Code 1 (or Master Code)> - <ENTER>
LCD displays “CLIENT MODE”
Note: Default Master Code (Code 1) is 1,2,3
You are now in Client Program Mode. When you are in Client programming mode you have access to program
addresses P1E to P100E (user code programming). To Enter Installer Program Mode from Client Program
Mode;
Press <PROGRAM> - <Install Code> - <ENTER>
LCD displays “INSTALLER MODE”
Note: Default Installer Code (P410E) is 0,0,0,0,0,0
By default the installer can go directly to Installer Program Mode from Normal Run mode provided No Areas are
Armed or in Stay Mode. The Installer Mode direct option can be disabled at address P601E Option 3.
HOW TO PROGRAM YOUR PW64 PANEL
The programming sequence always follows this pattern once you have accessed one of the Program Modes;
<PROGRAM> - <1,2,3 or 4 digit address> - <ENTER>
3 short beeps if OK - 1 long beep if error
The LCD will display current value or status
Enter the new value or option
<New Value> - <ENTER>
3 short beeps if OK - 1 long beep if error
An example of programming is shown below. Here we are programming User Code 23 (P23E) with the code
number of 2580.
P 23 E 2,5,8,0 E
In this example the <P> represents the PROGRAM key, <23> represents the actual program address, 2580 is the
data and <E> represents the ENTER key.
TO CLEAR PROGRAM INFORMATION (From Installation Mode Only)
To Next Page
Loading...
