Page 47
for your access code. This process will be repeated 4 times before hanging up if no valid code is received. When
entering codes or other information in Command Control the "#" key acts as a "Clear" button.
When you have entered the required 4 digit access code the panel will reply with the status message associated with
that menu option. For example, lets say we have a code of 2045 programmed at address P741E, (the code for
Arming & Disarming Area A). Once the code “2045” has been received the panel checks the current status of Area A
and replies with either the canned message or the customised voice message assigned at address P861E or P865E
that relates to the status e.g. if Area A is Armed then the Armed message will be sent, if Disarmed then the Disarmed
message will be sent.
Once the status message has informed you of the actual state, you can use the "*" key to toggle the option on & off
or Arm and Disarm, e.g. in our example above, code 2045 accesses the Area "A" menu. Assuming the status
message we received was "Area A alarm is Armed" If we press the "*" key, Area "A" will be Disarmed and we would
receive a status message "Area A alarm is Disarmed".
While you are on-line with the panel you can move between menu options by entering the code of the option you
want to control. Assuming there was a code of 4321 programmed at address P745E, to control outputs. After having
used code 2045 to control the Arm/Disarm status of Area A we first press the “#” button to reset all previous entries
then we can enter the digits 43215 (that is 4321 for the output control and 5 to select output #5). The current status of
output #5 will be given either by the canned or customised voice message and then the status can be changed with
the “*” button on the remote telephone (Note; For output control you must enter in the 4 digit code e.g. 4321 followed
by the output number you wish to control, in this case 5).
At any stage, if you enter in an incorrect code you can press the “#” button on the remote telephone to clear all code
entries and then start again.
To end a Command Control session simply hang up the phone. The panel is monitoring the line at all times and 15
seconds after the last key press it will automatically hang up the line. This 15 second timer is active during the whole
command control process so a period of 15 seconds without a key press will cause the panel to hang-up.
LOCAL COMMAND CONTROL OF OUTPUTS
If a command control code for outputs is programmed (P745E) and the output/s are allowed to be locally controlled
(P541-P548, option 6) then entering the 4 digit code at a keypad will allow direct control of the outputs. The LCD
display will show “OUTPUTS” to indicate that local command control is active. At this stage any outputs that are on
will be shown on the LCD display e.g. if output 1 is on the number 1 will be on. By now pressing the “1” button at the
panel keypad, output 1 can be turned off provided it is allowed to be locally controlled. To leave local command
control mode simply press the “Enter” button and the keypad will return to normal operation. If the “Control” button is
enabled at address P646E then you can access this Local Command Control mode directly by simply pressing the
“Control” button at the keypad followed by the output number/s that are allowed to be controlled.
To Next Page
Loading...
