Page 9
PW64 LCD KEYPADS
KEYPAD FUNCTIONS
The PW64 LCD Keypad consists of 21 backlit silicon rubber buttons, 2 line x 16 character LCD display and an
internal piezo buzzer housed inside the PW64 white plastic housing.
Additional slim-line LCD keypads can be hardwired to the panel, if required, via the keypad buss terminal blocks
labelled Pos, Neg, Clk & Dat.
BUTTONS
The 21 silicone rubber buttons are used for the following functions;
a-In normal operating mode the numeric keys are used for entering Access Codes. In Program Mode the
numeric keys are used for entering program addresses & new values.
b-The buttons with text labels are used as function buttons and select the options indicated by the text
and normally precede other button presses, e.g. to enter Bypass Mode press <BYPASS> and a two digit
numeric key entry corresponding to the zone number you wish to be excluded eg “01” for Zone # 1, “09”
for Zone # 9 and “15” for Zone # 15. Your selections will be shown on the LCD display.
c-The PROGRAM Key is used to prefix option selections in the program modes e.g. <PROGRAM> 24
<ENTER> selects User Code 24 when in either of the two program modes. The PROGRAM key is also
used prior to a Master or Installer Code to enter one of the program modes from normal operating mode.
d-The ENTER Key is used after entry of a sequence of numbers (eg entry of a User code to Arm or Dis
arm the system). As a User code can be 1-6 digits in length, the panel will not accept a code entry until
the Enter key is pressed.
e-The CONTROL button, if enabled, is used to either turn an output on/off or disable the Day Mode
alarms. The control output can be used to operate other external devices such as garage door openers,
door locks, lights, etc.
LED INDICATORS
The LED indicators are used to display system conditions such as “Trouble” alarms and “Bypass” active. They
also indicate armed status of the panel and if all zones are in the clear “Ready” state prior to arming.
KEYPAD TAMPER (wrong code alarm)
A wrong code or Keypad Tamper alarm is generated by the PW64 after 4 consecutive invalid code entries. The
controller will not “Lock-Out” the keypad at this point but simply create an alarm condition that may be reported to
a monitoring company via the dialler. Entry of a valid user code will reset the Keypad Tamper alarm, however, the
alarm event will be written into memory and the keypad will display “New Event” indicating the presence of a new
memory entry.
To Next Page
Loading...
