Page 5
INTRODUCTION
The PwerWave 64 Wireless alarm control panel has been designed to provide the most requested features for both
the installer & the end-user. These features include ease of installation, ease of programming and user friendly
operation all in a package which is reliable, functional and attractive.
Utilising many years of experience in the security industry and implementing valuable feedback, we are proud to
provide you with a new generation of alarm controller. The PowerWave 64 is a New Zealand designed and built
product which brings you the quality and features which you deserve at an affordable price. In addition to the
advanced design, only the highest quality components have been used in the production of this panel to ensure the
highest degree of reliability.
This manual will guide you through the installation and programming of your alarm panel. For additional information
regarding the operation instructions and options, please refer to the enclosed “User’s Guide”.
PACKAGE CONTENTS
This Crow PowerWave 64 (PW64) package should contain the following items;
1 x PW64 controller PCB
1 x PW64 LCD keypad
1 x PW64 keypad zone list
1 x PW64 Radio receiver card
1 x Speaker/Microphone and internal piezo siren
1 x PW64 Users Guide
1 x PW64 polycarbonate housing
1 x 17 volt 1.4a mains transformer
1 x Cabinet hardware accessory pack including,
1 x Cabinet tamper switch
1 x Battery lead set
2 x Cabinet lid screws
4 x 2k2 (red, red, red) end of line resistors
4 x 4k7 (yellow, purple, red) end of line resistors
4 x 8k2 (grey, red, red) end of line resistors
If any of these items are missing from this package, please contact the Crow branch where you placed your order.
To Next Page
Loading...
