Page 13
There are multiple options available for clearing program information (Reset to
defaults). These are detailed on page 78.
e.g. To reset User Codes 1-100 (P 960E)
Press <PROGRAM> - 960 - <ENTER>
3 beeps
After resetting the various defaults, all options associated with that function (eg User Code Defaults P960E) will be
set to the default values shown in the Program Summary at the rear of this manual. The default settings have been
chosen to simplify the installation process by minimising the amount of programming necessary to get the system
fully functional.
TO EXIT PROGRAM MODES
To exit program modes when you have finished programming:
Press <PROGRAM> - <ENTER>
The panel is now back in normal Run Mode, any program changes you have made will have replaced previous
values and be in effect.
Note: While in Program Mode, Tampers and 24 hour alarms are disabled which allows quiet access to the panel,
satellite siren units etc. Also, the panel cannot be armed while in program mode. On exiting program mode, all inputs
are scanned and if any tampers or 24Hr alarms are present an activation will occur.
Note: Where there are multiple options at one address, the numbers “0” & “9” have been reserved. Entering
a “0” at the address will turn all options OFF at that address whereas entering a “9” will turn all options ON
at that address.
USER CODE PROGRAMMING
USER CODES - (P1E to P100E) & INSTALLER CODE - (P410E)
There are 101 codes available in the PW64, 100 user codes and 1 installer code. A User code can be a dedicated
code that must be entered at the keypad or it can be a Radio Key. Radio keys can occupy User code slots 21-100. If
a radio key has been loaded as a User, that user slot is not available to be used as a code. The user codes are
located at addresses 1-100. By default, Code 1 is the Master Code because it has full access to enter program
mode. Other user codes can be programmed as master codes also if required. The Installer code is stored at
address 410 and is used to move from Client Program mode up to Installer Program mode.
Codes 1-100 may be varied in length from 1 to 6 digits. Code 410 (Installer Code) must be 3-6 digits.
To program a User Code you must first be in client or installer program mode, then select the address from 1-
100. (If there is already a code programmed at this address, it will be displayed to you. If the slot has a Radio key
user loaded then you will get a long error beep when you enter the address)
NOTE: Not all User Codes may have the ability to access Client Program Mode. The installer can restrict access to
Users so that they have no access to Client Mode or they can have access to change only their code or they may
have access to change all User codes as defined at addresses P221-P240.
To change User code 1 from the default setting of 1,2,3 to 9,8,7,6 you would enter the following data at the keypad.
P 1 E
(Old code is displayed at the keypad, in this case it will be 1,2,3)
Then 9876 E
3 beeps
The new code will now be displayed
To program a code of 5,6,7 for User 50 you would enter the following;
P 50 E
(If a code was there it would be displayed if not the display will be blank )
Then 567 E
3 beeps
To Next Page
Loading...
