Custom Audio Electronics KPM216HII-ETH - Setup.ini File Configuration

The “Setup.ini” fi le is a confi guration fi le that contains all the confi gurable parameters listed in text format and divided
into some sections (indicated in square brackets).
The available values for every parameter, are listed after the parameter name. The value marked with the symbol ‘ *
’ is the default one.
To modify printer’s parameters, change the numeric value after the name of parameters. To set the parameter to the
default value, change the numeric value with the symbol D.
The “Setup.ini” fi le permits the confi guration of the following parameters:
[PRINT]
Printer Emulation: 0, 1* 0 = ESC/POS
TM
1 = SVELTA
Print Mode: 0*, 1 0 = Normal
1 = Reverse
Autofeed: 0*, 1 0 = CR disabled
1 = CR enable
Chars / inch:
200 dpi models 0, 1* 0 = A=11 B=15 cpi
1 = A=15 B=20 cpi
300 dpi models 0, 1* 0 = A=16 B=23 cpi
1 = A=23 B=30 cpi
Speed / Quality: 0, 1*, 2 0 = High Quality
1 = Normal
2 = High Speed
Automatic Ejecting: 0*, 1, 2, 3, 4, 5, 6, 7, 8 0 = Disabled
1 = Enabled T.out 5 S
2 = Enabled T.out 10 S
3 = Enabled T.out 15 S
4 = Enabled T.out 20 S
5 = Enabled T.out 30 S
6 = Enabled T.out 40 S
7 = Enabled T.out 60 S
8 = Enabled T.out 2 m
Paper Retracing: 0*, 1, 2, 3, 4, 5, 6,
7, 8, 9
0 = Disabled
1 = Enabled NoTimeout
2 = Enabled T.out 5 S
3 = Enabled T.out 10 S
4 = Enabled T.out 15 S
5 = Enabled T.out 20 S
6 = Enabled T.out 30 S
7 = Enabled T.out 40 S
8 = Enabled T.out 60 S
9 = Enabled T.out 2 m
Paper Width: 0, 1, 2, 3, 4, 5,
6, 7, 8, 9, 10,
11, 12, 13, 14*
0 = 172 mm
1 = 174 mm
2 = 176 mm
3 = 178 mm
4 = 180 mm
5 = 182 mm
6 = 184 mm
7 = 186 mm
8 = 188 mm
9 = 190 mm
10 = 192 mm
11 = 194 mm
12 = 196 mm
13 = 198 mm
14 = 200 mm
Paper Threshold: 0*, 1, 2, 3, 4, 5, 6 0 = 30 %
1 = 40 %
2 = 50 %
3 = 60 %
4 = 70 %
5 = 80 %
6 = 90 %
12. ADVANCED FUNCTIONS
108 KPM216HII ETH User manual