Custom Audio Electronics KPM216HII-ETH - Page 61

ISOPROPYL ALCOHOL
A
4
Clean the ejector roller by using
a soft cloth moistened with isopropyl.
EJECTOR
1
Disconnect the
power supply cable.
2
Lift up the ejector cover (A).
3
Lift up the guide and remove any scraps of paper
and the accumulated paper dust inside the ejector.
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the machine.
ON
Alcohol, solvent
cohol, solve
6. MAINTENANCE
User manual KPM216HII ETH 61