The following fi gure shows an example of paper with alignment point set by a positive value of “Notch Distance”
(“Notch Distance” = + A):
+A
0
PRINTING DIRECTION
alignment point
notch front
To set a negative value of the “Notch Distance” parameter is useful in cases where the alignment point refers to the
notch printed on the previous ticket or where the desired cutting line is placed in the middle of the alignment notch (for
example, for paper with holes or gap). In the following images, the value of “Notch Distance” parameter is set to -A.
PRINTING DIRECTION
Alignment point
Notch front
- A
0
10. ALIGNMENT
88 KPM216HII ETH User manual
To Next Page
Loading...
Need help?
General
