4 Web-based Switch Configuration D-Link Smart Managed Switch User Manual
1
1
0
0
9
9
Figure 4.138 - Add Access Rule – IPv4 UDP
IPv4 Address: Defines the range of source Ports relevant to the ACL rules.
Source: Defines the range of source Ports relevant to the ACL rules. For example, to set 0 – 15, set mask of
FFF0.
Destination: Defines the range of destination IP addresses, relevant to the ACL rules. For example, to set
0 – 15, set mask of FFF0.
Click Next button then the ACL profile is added.
• To define the IPv4 ACL Protocol ID Rule: Select IPv4 ACL and click Next button. Select the
Protocol Type to Protocol ID, the updates to show the follows:
To Next Page
Loading...
