4 Web-based Switch Configuration D-Link Smart Managed Switch User Manual
110
Figure 4.139 - Add Access Rule – IPv4 Protocol ID
IPv4 Address: Defines the range of source Ports relevant to the ACL rules.
Source: Defines the range of source Ports relevant to the ACL rules. For example, to set 0 – 15, set mask of
FFF0.
Destination: Defines the range of destination IP addresses, relevant to the ACL rules. For example, to set
0 – 15, set mask of FFF0.
Protocol ID (0-255) – Specifies the Protocol ID to be configured.
Click Next button then the ACL profile is added.
NOTE: A combination of one or several filtering
masks can be selected simultaneously. The page
updates with the relevant field(s).
• To define the IPv6 ACL ICMP rule: Select IPv6 ACL with ICMP of Protocol Type and click Next
button. The updates to show the follows:
To Next Page
Loading...
