D-Link DSL-2888A - Adsl

28D-Link DSL-2888A User Manual
Section 4 - Conguration
ADSL is one of the rst home broadband technologies introduced. ADSL uses the DSL port
on your DSL-2888A to connect to the Internet. In order for your DSL-2888A to use ADSL,
you must congure the ADSL Settings, your ISP Settings, and your IPv4/IPv6 Settings.
WAN Access Type:
Select ADSL to congure ADSL connection settings.
Interface:
Select the interface from the drop-down menu. ATM0-ATM7 are
available. The default is ATM0.
Enable Interface:
Select whether to enable or disable this interface.
ISP Settings
VPI:
Enter the Virtual Path Indicator (0 - 255).
VCI:
Enter the Virtual Channel Indicator (32 - 65535).
VLAN Tagged:
Enable or disable VLAN tagging.
If you enabled VLAN Tagged, the following options are available:
VLAN ID:
Enter the VLAN ID. The value should be 0, or 0-4079.
VLAN Priority:
Enter the VLAN Priority from the default 0 (lowest) to 7 (highest).
Advanced Settings
Encapsulation:
Select the method of encapsulation provided by your ISP. You can
select LLC or VCMUX.
ATM QoS:
Select the Quality of Service type from the drop-down menu.
Congure the associated settings
Proceed to IPv4 Settings on page 32 or IPv6 Settings on page 36.
ADSL
DSL-2888A HW:V1.0.0 FW:V1.1.43
Settings >> Internet
SettingsHome Features Management
Internet
Use this section to congure your Internet Connection type. There are several connection types to choose
from Static IP, DHCP, PPPoE, PPTP, L2TP and DS-Lite. If you are unsure of your connection method, please
contact your Internet service provider. Note: If using the PPPoE option, you will need to remove or disable
any PPPoE client software on your computers.
Advanced Settings ...
WAN Access Type: ADSL
⌵
Interface:
ATM 0
⌵
Enable Interface:
Enabled
Priority
Save
DSL Prole
VPI:
VCI:
VLAN Tagged:
Enabled
VLAN ID:
VLAN Priority: Disable
⌵
Encapsulation:
VC MUX
⌵
ATM QoS:
Non Realtime VBR
⌵
Sustainable Cell Rate: undened
Maximum Burst Size:
undened
Minimum Cell Rate:
undened
ISP SETTINGS