D-Link DSL-2888A - Dynamic IP (DHCP)

33D-Link DSL-2888A User Manual
Section 4 - Conguration
IPv4 SETTINGS
Advanced Settings ...
Host Name:
Primary DNS Server:
Secondary DNS Server:
MTU: Auto
⌵
Mac Address Clone: << MAC Address
⌵
Enable NAT:
Enabled
My Internet Connection is: Dynamic IP (DHCP)
⌵
Dynamic IP (DHCP)
Select Dynamic IP (DHCP) to obtain an IP address automatically from your ISP. Select this
option if your ISP does not provide you with a specic IP address.
IPv4 Settings:
My Internet
Connection is:
Select Dynamic IP (DHCP).
Advanced Settings
Host Name:
The host name is optional but may be required by some ISPs. Leave
it blank if you are not sure.
Primary DNS
Server:
Enter the primary DNS server IP address assigned by your ISP. This
address is usually obtained automatically from your ISP.
Secondary DNS
Server:
Enter the secondary DNS server IP address assigned by your ISP. This
address is usually obtained automatically from your ISP.
MTU:
Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
MAC Address
Clone:
The default MAC address is set to the Internet port’s physical interface
MAC address on the router. You can use the drop-down menu to
replace the Internet port’s MAC address with the MAC address of a
connected client.
Enable NAT:
Enable or disable Network Address Translation.
Proceed to IPv6 Settings on page 36 or click Save when you are done.