D-Link DSL-2888A - Ipv4 Settings; Static IP

32D-Link DSL-2888A User Manual
Section 4 - Conguration
Static IP
Select Static IP if your ISP provides you with a specic IP address.
IPv4 Settings:
My Internet
Connection is:
Select Static IP.
IP Address:
Enter the IP address provided by your ISP.
Subnet Mask:
Enter the subnet mask provided by your ISP.
Default Gateway:
Enter the default gateway address provided by your ISP.
Primary DNS
Server:
Enter the primary DNS server IP address assigned by your ISP. This
address is usually obtained automatically from your ISP.
Advanced Settings
Secondary DNS
Server:
Enter the secondary DNS server IP address assigned by your ISP. This
address is usually obtained automatically from your ISP.
MTU:
Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
MAC Address
Clone:
The default MAC address is set to the Internet port’s physical interface
MAC address on the router. You can use the drop-down menu to
replace the Internet port’s MAC address with the MAC address of a
connected client.
Enable NAT:
Enable or disable Network Address Translation.
Proceed to IPv6 Settings on page 36 or click Save when you are done.
IP Address:
Subnet Mask:
Default Gateway:
Primary DNS Server:
Advanced Settings ...
My Internet Connection is: Static IP
⌵
Secondary DNS Server:
MTU: Auto
⌵
Mac Address Clone: << MAC Address
⌵
Enable NAT:
Enabled
IPv4 SETTINGS
IPv4 Settings