D-Link DSL-2888A - Usb

31D-Link DSL-2888A User Manual
Section 4 - Conguration
WAN Access Type:
Select USB to congure USB connection settings.
Interface:
Select the interface from the drop-down menu.
Enable Interface:
Select whether to enable or disable this interface.
ISP Settings
Country: Select your country.
ISP: Select your ISP. A number of ISP conguration settings are pre-
programmed into the DSL-2888A for convenience. If you don't see
your ISP or wish to use manual settings, choose Not Listed.
PIN Code: Enter your PIN code.
Dial Number: Enter the Dial Number.
APN: Enter the APN.
Username: Enter your username.
Password: Enter your password.
There is no further conguration. Click Save when you are done.
The DSL-2888A supports USB mobile broadband adapters. You can connect a mobile
broadband adapter and share your cellular network connection with your home network.
For a list of supported adapters, visit www.dlink.com.
This page provides conguration settings for your USB mobile broadband connection.
Refer to your mobile broadband adapter's documentation for setup instructions and ISP
for conguration information. In most cases, the process is plug and play and requires no
further conguration.
DSL-2888A HW:V1.0.0 FW:V1.1.43
Settings >> Internet
SettingsHome Features Management
Internet
Use this section to congure your Internet Connection type. There are several connection types to choose
from Static IP, DHCP, PPPoE, PPTP, L2TP and DS-Lite. If you are unsure of your connection method, please
contact your Internet service provider. Note: If using the PPPoE option, you will need to remove or disable
any PPPoE client software on your computers.
WAN Access Type:
USB
⌵
Interface:
USB 0
⌵
Enable Interface:
Enabled
Priority
Save
DSL Prole
Country:
New Zealand
⌵
ISP:
Not Listed
⌵
PIN Code:
Dial Number:
APN:
Username:
Password:
ISP SETTINGS
COPYRIGHT © 2016 D-Link
USB