D-Link DSL-2888A - Pppoe

34D-Link DSL-2888A User Manual
Section 4 - Conguration
My Internet Connection is: PPPoE
⌵
Advanced Settings ...
Username:
Password:
Reconnect Mode: Always On
⌵
IPv4 SETTINGS
Address Mode: Dynamic IP
⌵
Service Name:
Primary DNS Server:
Secondary DNS Server:
MTU: Auto
⌵
Enable NAT:
Enabled
Address Mode: Static IP
⌵
IP Address:
Service Name:
Primary DNS Server:
Secondary DNS Server:
MTU: Auto
⌵
Enable NAT:
Enabled
PPPoE
Select PPPoE if your ISP provides and requires you to enter a PPPoE username and password
in order to connect to the Internet.
IPv4 Settings:
My Internet
Connection is:
Select PPPoE.
Username:
Enter the username provided by your ISP.
Password:
Enter the password provided by your ISP.
Reconnect Mode:
Select either Always-on, On-Demand, or Manual.
Advanced Settings
Address Mode:
Select Static IP if your ISP assigned you an IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic IP.
IP Address:
Enter the IP address provided by your ISP. Static IP only.
Service Name:
Enter the ISP service name (optional).
Primary DNS
Server:
Enter the primary DNS server IP address assigned by your ISP. This
address is usually obtained automatically from your ISP.
Secondary DNS
Server:
Enter the secondary DNS server IP address assigned by your ISP. This
address is usually obtained automatically from your ISP.
MTU:
Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
Enable NAT:
Enable or disable Network Address Translation.
Proceed to IPv6 Settings on page 36 or click Save when you are done.