D-Link DWL-8600AP User Manual

Configuring L2 Features
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 181
D-Link UWS User Manual
Section 4: Configuring L2 Features
Use the pages in the L2 Features navigation tree folder to configure the Layer 2 switching features available
on the D-Link DWS-4000 Series switch. The L2 Features folder contains links to the following features:
• “Configuring and Searching the Forwarding Database”
• “Managing VLANs”
• “Configuring Protected Ports”
• “Creating MAC Filters”
• “Configuring GARP”
• “Creating Port Channels (Trunking)”
• “Configuring IGMP Snooping”
• “Configuring IGMP Snooping Queriers”
• “Configuring MLD Snooping”
• “Configuring MLD Snooping Queriers”
• “Viewing Multicast Forwarding Database Information”
• “Configuring Spanning Tree Protocol”
• “Configuring DHCP Snooping”
• “Managing LLDP”
• “Configuring Dynamic ARP Inspection”

D-Link DWL-8600AP Specifications

General

Modulation	DBPSK, DQPSK, DSSS, OFDM
Cabling technology	10/100/1000Base-T(X)
Maximum data transfer rate	300 Mbit/s
Frequency range	2400 - 2497 MHz
Wireless technology	802.11a/b/g/n
Compliance industry standards	IEEE 802.11a, 802.11b, 802.11g, 802.11n, IEEE 802.3, 802.3u, IEEE 802.11d, IEEE 802.11h, IEEE 802.3x, IEEE 802.3af
Antenna connector type	SMA
DC-in jack	Yes
Ethernet LAN (RJ-45) ports	1
AC input voltage	48 V
Power supply type	DC
Power consumption (typical)	12 W
Storage temperature (T-T)	-20 - 65 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 90 %
Certification	-FCC Class B, -CE, -C-Tick, -VCCI, -TELEC, -Wi-Fi, - ICES-003, -EN60601-1-2, -NCC, -CSA.

Weight and Dimensions

Weight	1020 g
Dimensions (WxDxH)	190.5 x 198.8 x 36.8 mm