Monitoring Status and Statistics
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 498
D-Link UWS User Manual
Since the associated client database supports roaming across APs, an entry is not removed when a client
disassociates from a specific AP. After a client has disassociated, the entry is deleted after the client times out.
You configure the timeout value in the Client Roam Timeout field on the WLAN > Administration > Advanced
Configuration > Global page. The timeout value corresponds to the time allowed for a client to roam to
another managed AP.
Viewing Associated Client Summary Status
Figure 324: Associated Client Status
Table 292 describes the information available on the WLAN > Monitoring > Client > Associated Clients >
Summary page for the associated client status.
Table 292: Associated Client Status Summary
Field Description
MAC Address The Ethernet address of the client station. If the MAC address is followed by an
asterisk (*), the client is associated with an AP managed by a peer switch.
AP MAC Address The Ethernet address of the AP.
SSID The network on which the client is connected.
BSSID The Ethernet MAC address for the managed AP VAP where this client is associated.
Detected IP Address The IP address of the associated client, if available.
NetBIOS Name The NetBIOS name of the wireless client. For Microsoft Windows hosts, the NetBIOS
name is typically the same as, or based on the host name of the client.
Location The configured descriptive location for the managed AP.
Channel The operating channel for the client association.
Radio The radio and mode.
Security Mode The type of encryption in use.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
