Basic Setup
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 547
D-Link UWS User Manual
The APs process the discovery message only when it comes in on the management VLAN. The APs do not
forward the L2 discovery messages onto the wireless media.
From the DWS-4000 Series switch, you can check the discovery status of APs and peer switches. To view
information about whether the switch discovered any APs, navigate to the WLAN > Monitoring > Access Point
> Managed AP Status page. If you have not added the MAC address of the AP to the local or RADIUS Valid AP
database, the AP appears in the WLAN > Monitoring > Access Points > AP Authentication Failure Status list,
and the failure type is listed as No Database Entry.
To view information about whether the switch discovered any peer switches, navigate to the WLAN >
Monitoring > Peer Switch page.
Command Buttons
The page includes the following buttons:
• Add—Adds the data in the IP Address or VLAN field to the appropriate list.
• Delete—Deletes the selected entry from the IP or VLAN list.
• Refresh—Updates the page with the latest information.
• Submit—Updates the switch with the values you enter. To retain the new values across a power cycle,
you must perform a save on the WLAN switch (not the AP). To perform a save, click Tool > Save Changes.
• Next—Navigates to the next page in the Basic Setup configuration. Any changes you made to the current
page are saved before the next page is displayed. To retain the new values across a power cycle, you must
perform a save on the WLAN switch (not the AP). To perform a save, click Tool > Save Changes.
VLAN To add entries to the VLAN List, enter a valid VLAN ID (1 - 4094) and click Add.
Once all desired entries are added, click submit to save the list in the running
configuration.
Table 326: L2/VLAN Discovery
Field Description
To Next Page
Loading...
Need help?
General
Weight and Dimensions
