136
Table 4-44 FTP parameter description
Parameters Description
Server Address The IP address of the SFTP or FTP server.
Port The port of the SFTP or FTP server.
User name The user name to log in the server.
Password The password to log in the server.
Remote Directory The destination path in the server.
Emergency (Local)
Select the Emergency (Local) check box, and when the FTP server does
not work, all the files are saved to the internal SD card.
Click Save. Step 4
Click Test to check whether the server has been properly connected.
4.7.2.4 Configuring NAS Server
This function can be enabled only when NAS has been selected as destination path. Select NAS
interface and you can save files in NAS server.
Select Setting > Storage > Destination > NAS. Step 1
The NAS interface is displayed. See Figure 4-85.
NAS settings Figure 4-85
Select the Enable check box. Step 2
Configure NAS parameters. See Table 4-45. Step 3
Table 4-45 NAS parameters
Parameter Description
Server Address The IP address of the NAS server.
Remote Directory The destination path in the NAS server.
Click Save. Step 4
4.7.3 Configuring Record Control Parameters
This chapter introduces configurations including pack duration, pre-event record, disk full, record
mode and record stream.
Select Setting > Storage > Record Control. Step 1
The Record Control interface is displayed. See Figure 4-86.
To Next Page
Loading...
Need help?
General