68
Click Save. Step 3
Configuring Network 4.2
4.2.1 Configuring TCP/IP
You need to configure the camera’s IP address and DNS server to connect the camera with other
Cameras in the network.
Preparation
You have connected the camera to network.
Procedure
Select Setting > Network > TCP/IP. Step 1
The TCP/IP interface is displayed. See Figure 4-24.
TCP/IP interface Figure 4-24
Configure TCP/IP parameters. See Table 4-13. Step 2
Table 4-13 TCP/IP parameters
Parameter Description
Host Name Enter host name, 15 characters at most.
Ethernet Card
Wire (Default) is set by default.
To Next Page
Loading...