146
When accessing through WAN, you can only use MAC of your router to limit MAC verification.
You cannot enable white list and black list at the same time.
You cannot add your Camera IP/MAC to the white list.
Select Setting > System > Safety > IP Filter. Step 1
The IP Filter interface is displayed. See Figure 4-101.
IP filter Figure 4-101
Select the check box of Enable. Step 2
Add an IP/Mac address to the white list.
1) Click the Trusted Sites tab.
The Trusted Sites interface is displayed.
2) Click Add IP/MAC.
The dialogue box of Add IP/MAC is displayed.
3) Set IP/MAC address. See Table 4-50.
Table 4-50 IP/MAC address parameters description (trusted sites)
Parameter Description
IP address IP address you are going to authorize.
IP segment Start address and end address of the IP segment.
MAC address MAC address you are going to authorize.
4) Click Save.
Add an IP/Mac address to the black list.
1) Click the Banned List tab.
The Banned List interface is displayed.
2) Click Add IP/MAC.
The dialogue box of Add IP/MAC is displayed.
3) Set IP/MAC address. See Table 4-51.
Table 4-51 IP/MAC address parameters description (banned list)
Parameter Description
IP address IP address you are going to prohibit.
IP segment Start address and end address of the IP segment.
MAC address MAC address you are going to prohibit.
4) Click Save.
Click Save. Step 3
4.8.4.3 Configuring System Service
You can set functions such as SSH, password reset, CGI service, Onvif service, genetec service, audio
and video transmission encryption and mobile push.
To Next Page
Loading...