22
Wiper Figure 3-11
Click Enable to enable the wiper; click Disable to disable it. Step 2
3.2.1.3 Operating PTZ
The corresponding protocol setting and function setting have been completed. See "3.2.1.1
Configuring Protocol" and "3.2.1.2 Configuring PTZ Functions" for more details.
For images representing the effect of external PTZ, you need to preview on the preview images
of the external PTZ, not on the preview image of the bullet camera.
Click the PTZ tab and the PTZ control panel is displayed on the right side of the PTZ interface. See
Figure 3-12.
PTZ control panel Figure 3-12
Table 3-6 Parameter description
No. Function Description
1 Direction button
Eight directions are contained: up, down, left, right, upper left, upper
right, lower left, and lower right.
2 Speed
Controls the movement speed. The bigger the value is, the faster the
movement will be.
With this function, you can also change the speed of adjusting the
PTZ direction, zooming, changing the focal length and adjusting the
aperture.
To Next Page
Loading...