24
3.2.2.2 Configuring PTZ Functions
Select Setting > PTZ > Function and the Function interface is displayed.
It’s set by default that the thermal image is displayed. In the thermal image, you can click to
switch the image to visible image. And, in the visible image, you can click to switch the image
to thermal image.
3.2.2.2.1 Configuring Preset
By configuring presets, the camera can store parameters such as PTZ’s horizontal angle, inclination
angle, and the lens focal length under the current situation to the Camera. If you need those
parameters later, you can quickly adopt them and adjust the PTZ and camera to those locations.
Select Setting > PTZ > Function. Step 1
The Preset interface is displayed. See Figure 3-15.
The preset interface Figure 3-15
Configure preset. Step 2
1) Click Add to add a new preset.
2) Operate the PTZ control panel to move the camera lens to a specific direction you need.
3) Double-click the preset’s Number to modify it.
4) Double-click the preset’s Preset Title to modify it. Then click .
Click to delete a preset that is wrongly configured or that is not
needed anymore.
Click Delete to delete all the presets you have added.
To Next Page
Loading...