26
Select Setting > PTZ > Function > Scan. Step 1
The Scan interface is displayed. See Figure 3-17.
The scan interface Figure 3-17
Configure scan. Step 2
1) Select a Scan No. and set its Speed.
2) Click Setup.
Buttons of Set Left Limit and Set Right Limit are displayed.
3) Operate the PTZ control panel and move the camera to a left border you want and click
Set Left Limit; move the camera to a right border you want and click Set Right Limit.
Select a Scan No. and click Start to start scan. Step 3
Click Stop to stop the scan.
3.2.2.2.4 Configuring Pattern
The function of "pattern" can record continuously the user’s manual operation to the PTZ and record
the moving tracking of the camera’s lens. The camera will make the location where the recording
begins as the beginning point, and move back and forward automatically following the preset
movement pattern.
Select Setting > PTZ > Function > Pattern. Step 1
The Pattern interface is displayed. See Figure 3-18.
To Next Page
Loading...