29
The idle motion interface Figure 3-21
Configure idle motion. Step 2
1) Select the Enable check box to enable this function.
2) Select an idle motion and set idle time.
After you have set a value of idle time, when the time when you do not operate the PTZ
is longer than that value, the idle motion will be implemented immediately.
3) Click Save.
3.2.2.2.8 Configuring Power Up
If you want the PTZ to implement certain actions after the camera is powered, configure this
function.
Select Setting > PTZ > Function > Power Up. Step 1
The Power Up interface is displayed. See Figure 3-22.
To Next Page
Loading...