75
SMTP (Email) Figure 4-29
Configure your SMTP server. Step 2
For SMTP (Email)’s other parameters to be configured, see Table 4-16. Step 3
Table 4-16 SMTP (Email) parameter description
Parameter Description
Anonymity
Enable Anonymity, and senders’ identities will not be displayed in Emails
transmitted to others.
Sender Sender’s email address
Encryption type Select Authentication type from None, SSL and TLS. TLS is set by default.
Attachment Select the check box to support attachment in the email.
Title
You can enter no more than 63 characters in Chinese, English, and Arabic
numerals.
Receiver Receiver’s mail address. Supports 3 addresses at most.
Interval
Time intervals of sending alarm Emails. "0" means there is no interval. Set a time
interval (normally >0s) as you want and when alarm, video detection, or event is
triggered, Emails will not be transmitted all the time but be transmitted in the
time interval you have set. This function is aimed at easing the pressure that is
put on the Email server when there are quite a lot of abnormal events.
Health Mail
The system sends test mail to check if the connection is successfully set. Select
Health Mail to configure Update Period. E-mail testing results will be
transmitted in time intervals you have set.
Test
Test the email sending and receiving function. If the configuration is correct, you
would receive test email. Save email configuration before running rest.
Click Save. Step 4
To Next Page
Loading...
Need help?
General