Daikin DCS601C51 - Permit; Inhibit Setting of Ventilation; Remote Control Operations

25
Screen 1 Monitoring
Screen 2 Set
Screen 3 Advanced Operatioon
1
4
7
5
6
3
2
1.
On the Monitoring Screen Screen 1,
select a zone or group by pushing the
button 1 .
Perform the following procedure to enable or
disable the ventilation remote control
operations.
For this operation, you can select any of
three display types, icon, detailed icon and
list on the Monitoring Screen.
You may enable or disable the remote
control operations in units of zones or
groups.
∗ Note that some models of ventilation
systems permit you to make the above
settings but some models don’t.
2.
To select a zone or group subject to
ventilation volume switching, push the
icon 2
.
3.
4.
Push [Advanced Operation] button 4
to display the Advanced Operation
Screen Screen 3.
5.
Make a desired setting on the pull-down
menu 5 .
You can enable or disable the following
setup items for remote control:
Disabling remote control operations
Enabling only stop operation
Assigning priority to button pushed
later
After making the setting, push [OK]
button 6 to display the Set Screen
Screen 2 again.
To cancel above settings, push
[Cancel] button.
[Procedure]
Push [Set] button 3 to display the Set
Screen Screen 2.
6.
Lastly, push [OK] button 7 on the Set
Screen.
To cancel above settings, push
[Cancel] button.
Permit / Inhibit setting of Ventilation
Remote Control Operations