System Setup Menu Operation
1.
See page 56 and select Heating Optimization Settings.
2.
Screen 1 Heating Optimization Settings, which is
shown on the left, appears.
This screen shows current registration
status of Heating Optimization Settings.
3.
Touch an indoor unit to be added as shown
by 1 , and press the button 2 to add.
To deactivate this control, select an indoor
unit at 3 , and press the button 4 .
4.
Lastly, when all indoor units are registered,
press the [OK] button 5 .
(To cancel, press the [Cancel] button 6 .)
Screen 2 Confirmation Display appears.
When there is no problem in setting change,
press the [Yes] button 7 . This menu is ended,
and System Setup Menu appears.
To continue the change, press the [No]
button 8 . The screen 1 appears.
Before performing Heating Optimization Settings,
read thoroughly the section Heating Optimization
Settings on page 45, and perform the following
procedure.
Operation of Heating Optimization Settings
Screen 1 Heating Optimization Settings
Screen 2 Confirmation
3
1
4
2
4
3
4
4
5
5
6
6
7 8
75
To Next Page
Loading...
