viii
Warning labels indicating exposure to laser light and the device classification are applied
onto the head of the scanner (Figure A):
AVOID EXPOSURE
LASER RADIATION IS EMITTED FROM THIS APERTURE
AVOID EXPOSURE – LASER LIGHT
IS EMITTED FROM THIS APERTURE
Laser Safety Label for Oscillating Mirror and Standard Models
Warning and Device Class Label
The identification label is applied onto the bottom part of the scanner (Figure A, 2):
N2468
DATALOGIC AUTOMATION S.r.l. - Via Lavino 265
40050 Monte San Pietro (BO) ITALY
MANUFACT URED VOLT Amp.
JANUARY 2005 15-30 DC 1 .3-0.5
MODEL No.
SERIAL No.
This product conforms to the applicable requirements
of 21CFR 1040 at the date of manufacture.
Device Identification Label
Disconnect the power supply when opening the device during maintenance or installation to
avoid exposure to hazardous laser light.
The laser diodes used in this device are classified as Class 3B laser products according to
EN 60825-1 regulations and as Class IIIb laser products according to CDRH regulations. Any
violation of the optic parts in particular can cause radiation up to the maximum level of the
laser diode (35 mW at 630~680 nm).
POWER SUPPLY
This product is intended to be installed by Qualified Personnel only.
For all DS6300 models:
This device is intended to be supplied by a UL Listed Power Unit marked “Class 2” or LPS
power source, which supplies power directly to the scanner via the 25/26-pin connector.
This scanner must be supplied by a Class II Power Supply Unit conforming to the
EN 60950 safety regulation.
To Next Page
Loading...
Need help?
General
