Removal and Replacement
4-23
4.9 Thermal Transfer Assembly
Removal:
1. Turn OFF and unplug the printer.
2. Remove the three Screws that secure the Thermal Transfer Assembly and then remove
the Thermal Transfer Assembly from the Centerplate.
Screws
Thermal Transfer Assembly
Centerplate
Installation:
Position the Thermal Transfer Assembly over the opening in the Centerplate and secure it
using the three Screws.
4.9.1 Take-up Hub & Clutch Assembly
Removal:
1. Remove the Thermal Transfer Assembly; see Section 4.9.
2. Remove the C-Clip and Outer Bearing from the Take-Up Hub Shaft.
3. Slide the Take-up Hub and Inner Bearing out of the Assembly Casting then remove the
Clutch Assembly.
To Next Page
Loading...
