Removal and Replacement
4-24
Take-up
Hub Shaft
Inner
Bearing
C-Clip
Clutch
Assembly
Assembly
Casting
Outer
Bearing
Take-up Hub
Installation:
1. Position the Clutch Assembly and the Inner and Outer Bearings, as shown, in the
Assembly Casting.
2. Slide the Take-up Hub Shaft through the Inner Bearing, Clutch Assembly, and Outer
Bearing then insert the C-Clip onto the Take-up Hub Shaft to secure the components
within the Assembly Casting.
3. Install the Thermal Transfer Assembly; see Section 4.9.
4.9.2 Supply Hub
Removal:
1. Remove the Thermal Transfer Assembly; see Section 4.9.
2. Remove the Screw and Washer that secures Supply Hub in the Assembly Casting.
To Next Page
Loading...
