dbx DriveRack 480 - Navigating the Dynamics Section

®
Navigating the "Dynamics" Section
The PARAMETER knobs are used
to edit parameter values
1
2 3
The DYNAMICS button
toggles through
the Dynamics
modules used in
each channel of
the selected
program.
DYNAMICS
Compressor
Peakstop
Over Easy
DYNAMICS
Threshold
Ratio
Gain
Dynamics (Mono Compressor)
To edit the parameters of the Dynamics module used in a selected program, simply use the following procedure. From program mode,
either press the X-OVER button or use the Parameter 2 or 3 knobs to move to the Dynamics module. Once you have reached the Crossover module,
press either Parameter button to enter the module. Successive presses of DYNAMICS button will move
through each channel that utilizes a Dynamics module. Navigate through the Pages of the selected Dynamics module by pressing the
"Next Page" or "Prev Page" buttons successively until you arrive at the desired Page.
2.10 Navigating the Dynamics Section
Editing Functions
Section 2
DriveRack
™
21
DriveRack™ User Manual