dbx DriveRack 480 - Page 41

®
Configuring the DriveRack™
Section 3
DriveRack
™
29
DriveRack™ User Manual
• Once you are satisfied with the selected name, press the STORE button again and the
screen will appear something like this:
• If you wish to replace an existing User program, press the PARAMETER 1 knob and the
display will appear as follows:
• Use the Parameter 3 knob to select the USER program to be replaced. Once the pro-
gram to be replaced has been selected, press the STORE button once again and the
program will then be replaced.
• To store a program as a new USER program, press the STORE button and then press
the Parameter 2 knob to store as new and the display will appear as follows:
• At this point, use the Parameter 2 knob to select the position where the new USER pro-
gram will be stored.
STORE
Choose Place In The 
USER PROGRAM LIBRARY
To Insert The New
Program.

Press <STORE> To Save
Program.

4-Way FOH w/RTA
1 Replace Old
Parameter 3
STORE
Choose Program To Be
Replaced.

Press <STORE> To Save
Program.

4-Way FOH w/RTA
4-Way FOH w/RTA
Replacing:
Parameter 1
Parameter 2
STORE

1 Replace Old
2 Store New