V0215, 3.2
Product ID
A unique name to identify a product program. The maximum length is 25 characters.
The product ID may contain letters and numbers as available on the keyboard.
Product description
A name or description of this program. The maximum length is 25 characters. The
product description may contain letters and numbers.
If an existing product ID is entered, a warning appears that this product already exists. You are
asked whether to overwrite that existing product with the new product or not. If you choose
'yes', the existing product is erased. If you choose 'no', you must enter a new ID.
Thickness
Thickness of the sheet.
Material
Selection of the material type of the sheet. The control contains 4 pre-programmed
materials. See Settings to program materials. Press the required material to select it as
active.
Bending length
The Z-length of the sheet.
Dimensions
Determine the use of the outside (A) or the inside (B) dimensions in the product drawing
when new sides or surfaces are added. The figure below shows the definition of both
the dimensions. By default this parameter has the value of the Settings mode parameter
To Next Page
Loading...
