V0215, 3.3
Default Dimensions.
Radius
The product radius is recalculated after selecting the tools in the tool setup, because the
chosen tooling influences the resulting radius. By default this setting is ‘use calculated’.
With this parameter one can overrule and select ‘use programmed’; in that case the
product radius will not be recalculated and used as programmed.
Bend allowance
For the bend allowance of this product you could select ‘use calculated’ or ‘use
programmed’. With ‘use calculated’ the bend allowance will be calculated with the
Delem formula or the bend allowance table.
To change the active directory select ‘Save as’ and ‘Change directory’. The current product is
automatically copied to the new directory
To Next Page
Loading...
