V0215, 6.2
The main screen shows the existing numerical program or, when starting a new program, the
first to be programmed bend.
To change the main product properties tap Product Properties. These parameters of the
program are the same for every bending of the program (main data of program).
Functions
Connect
The function Connect is to have a possibility to connect certain programs to one another. This
option can be used to produce 3-dimensional products out of two programs.
+Connect program
With the function Connect it is possible to create a 3-dimensional product. The control
automatically executes the bend sequences in the different directions in succession. You
program the control as follows:
1 Create the product in one direction.
2 Create the product in the other direction.
There are now two bend programs of one product in two directions. You connect these
programs as follows:
1 Select the program with the bend sequence in the direction which you want to
execute in the first place. You select the program of the product via the ’product
library’.
2 Go to the Program mode and select Product properties.
3 In the Product properties window you select the function Connect and Connect
program.
To Next Page
Loading...
