V0215, 6.3
4 Select the product ID of the product in the other direction.
5 Select the second program as in step 1. Repeat steps 2 to 4. If you want to con-
nect two programs, as in this example, you enter the product ID of the first pro-
gram. The cycle is closed.
When you want to execute more than two programs in succession (not necessarily to create a
3-dimensional product) the second program must refer to the third. The third program to the
fourth and so on. The final program of the cycle must always refer to the first program.
To produce products with connected programs the next four actions are necessary.
1 Select the first program
2 Select the Automatic mode
3 Program the amount of products you want to produce with the ’stock count’
parameter.
4 Push the Start key.
When the first program has been finished the second program starts automatically. The
program counter indicates the remaining amount of repeats.
+Disconnect program
To stop the sequence of connected programs.
Save as
Copy the current product. When pressed, you must enter a new product ID for the copy
program.
Change directory
Choose another location (directory) on the local disk to store the current product. The product
is automatically copied to the new location.
To Next Page
Loading...
