Delem DA-58T - Page 70

V0215, 6.4
Parameter explanation
Product ID
A unique name to identify a product program. The maximum length is 25 characters.
The product ID may contain letters and numbers.
Product description
A number or description of this program. The maximum length is 25 characters. The
product description may contain letters and numbers.
Angle selection
Selection of the programming mode for the Y-axis.
0 = absolute: program the absolute Y-axis position for a bend.
1 =
α: program the angle to bend. The required Y-axis position is computed.
Depending on this parameter, either the parameter Angle or the parameter Bend
Position will appear in a bend step.
Thickness
Thickness of the sheet.
Material
Selection of one of the programmed materials, which are used to calculate the bending
depths. The control contains 6 pre-programmed materials. In total, 99 materials can be
programmed on the control. The materials can be programmed on the Materials page in
the Settings mode.
Blank length
The required length of the original sheet from which the product is bent. If the program
has been processed from a 2D drawing, this value has been calculated.
The main screen shows the available bends and from this main screen, from every available
bend, specific paremeters can be viewed and edited.
E-MODULE
(N/mm²)
TENSILE
STRENGTH
(N/mm²)
1 = Steel
2 = Aluminium
3 = Zinc
4 = Stainless steel
5 = Material 5
6 = Material 6
210.000
70.000
94.000
210.000
210.000
210.000
400
200
200
700
400
400