Dell EMC PowerEdge R740xd2 - M.2 SSD Module; Removing the M.2 SSD Module

NOTE: For buttery riser, tighten the captive screw to rmly hold the riser to the system
board.
Figure 105. Installing buttery riser
Next steps
1 If removed, install the rear drive cage.
2 Install the air shroud.
3 Install the system cover.
4 Place the system into the rack. For more information, see the Rail Installation Guide available at www.dell.com/poweredgemanuals.
5 Open the drive bays, install all drives, and then close the drive bays.
6 Install the power supply units.
7 Install any device drivers required for the card as described in the documentation for the card.
8 Follow the procedure listed in After working inside your system.
M.2 SSD module
Removing the M.2 SSD module
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Power o the system and all attached peripherals.
3 Disconnect the system from the electrical outlet, and disconnect the peripherals.
4 Open the drive bays, remove all drives, and then close the drive bays.
Installing and removing system components
131