Dell EMC PowerEdge R740xd2 - Installing the Microsd Card

5 Remove the power supply units.
6 Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
7 Remove the system cover.
8 Remove the air shroud.
9 Remove the IDSDM or vFlash module.
Steps
1 Locate the MicroSD card slot on the IDSDM/vFlash module, and press the card to partially release it from the slot.
2 Hold the MicroSD card and remove it from the slot.
NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal.
Figure 110. Removing the MicroSD card
Next step
Replace the MicrosSD card.
Installing the MicroSD card
Prerequisites
1 Follow the safety guidelines listed in Safety Instructions.
2 Power o the system and all attached peripherals.
3 Disconnect the system from the electrical outlet, and disconnect the peripherals.
4 Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5 Open the drive bays, remove all drives, and then close the drive bays.
6 Remove the power supply units.
7 Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
136
Installing and removing system components