Figure 45. Removing the drive from the drive carrier
Next step
If applicable, install a drive into the drive carrier.
Installing a drive into the drive carrier
Prerequisites
CAUTION
: Mixing drive carriers from other generations of PowerEdge servers is not supported.
NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 inch-pounds.
Steps
1 Insert the drive into the drive carrier with the connector end of the drive towards the back of the carrier.
2 Align the screw holes on the drive with the screws holes on the drive carrier.
3 Using a Phillips #1 screwdriver, replace the screws to secure the drive to the drive carrier.
Installing and removing system components
73
To Next Page
Loading...
