Dell EMC PowerEdge R740xd2 - Removing the Idsdm;Vflash Module; Installing Idsdm;Vflash Module

Removing the IDSDM/vFlash module
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Power o the system and all attached peripherals.
3 Disconnect the system from the electrical outlet, and disconnect the peripherals.
4 Open the drive bays, remove all drives, and then close the drive bays.
5 Remove the power supply units.
6 Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
7 Remove the system cover.
8 Remove the air shroud.
Step
Holding the pull tab, lift the IDSDM/vFlash module out of the system board connector .
Figure 108. Removing the optional IDSDM or vFlash card
Next step
NOTE
: If you are replacing the IDSDM or vFlash module, remove the microSD cards.
Replace optional IDSDM/vFlash module.
Installing IDSDM/vFlash module
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Power o the system and all attached peripherals.
3 Disconnect the system from the electrical outlet, and disconnect the peripherals.
134
Installing and removing system components