Figure 139. Removing the right control panel
Next step
Replace the right control panel.
Installing the right control panel
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Power o the system and all attached peripherals.
3 Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
4 Open the drive bays, remove all drives, and then close the drive bays.
5 Remove the power supply units.
6 Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
7 If installed, remove front bezel.
8 Remove the system cover.
9 Remove the air shroud.
10 Remove the internal PERC card.
Steps
1 Route the control panel cable through the right control panel cable clips and push the cable connector through the side of bay 2.
170
Installing and removing system components
To Next Page
Loading...
