4 Lift the right bracket away from the system and move the left bracket away from the drive bay.
Figure 53. Removing bay 2 backplane brackets
Next step
Replace the drive bay 2 backplane brackets.
Installing the drive bay 2 backplane brackets
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Power o the system and all attached peripherals.
3 Disconnect the system from the electrical outlet, and disconnect the peripherals.
4 Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5 If installed, remove the front bezel.
6 Open the drive bays, remove all drives, and then close the drive bays.
7 Remove the power supply units.
8 Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
9 Open the drive bays.
Steps
1 Align the backplane brackets with the slots at the bay base in drive bay 2.
2 Slide the brackets to the right until the brackets are rmly seated and lock into the place.
3 Using a Phillips #1 screwdriver, replace the screws on top of the drive bay 2.
Installing and removing system components
81
To Next Page
Loading...
